Wire & cable
Bare copper and alloy conductors for building wire, power cable and flexible cords.
Learn more
APPLICATIONS
Wire process knowledge, applied to your product.
Different wire products demand different combinations of slip, annealing, cooling and tension control. We configure the line around the end use, not the other way round.
APPLICATIONS
Built for the wire you make.
Our lines run in cable, enameled wire, electromagnetic wire, electronic wire, EDM wire and stainless steel production.
Enameled & magnet wire
Fine and ultra-fine copper wire with stable diameter and surface quality.
Learn moreElectronic & data cable
High-speed fine drawing for conductors used in electronics and data transmission.
Learn moreEDM cutting wire
Dedicated copper and brass drawing lines for electrode wire production.
Learn moreCopper-clad conductors
CCA and CCS drawing and conduit annealing with controlled copper layer integrity.
Learn moreStainless & alloy wire
Aluminium-magnesium and special alloy drawing with ceramic capstans and spray lubrication.
Learn more
LINE CONFIGURATION
A complete line, step by step
01
Pay-off
02
Drawing
03
Continuous annealing
04
Tinning (optional)
05
Cooling & lubrication
06
Tension control
07
Take-up & coiling
SELECTION GUIDE
Matching equipment to the product
A starting point for line selection. Final configuration depends on wire diameter, material, speed and spool size.
| Typical product | Recommended equipment | Why it fits |
|---|---|---|
| Bare copper conductor, 1.2–4.0 mm | Large wire drawing with continuous annealing | High tonnage, 13 dies, 2,100 m/min and 360 kVA annealing. |
| Fine copper wire, 0.08–0.32 mm | Fine wire drawing with continuous annealing | DC three-section annealing and PID synchronous spooling for stable elongation. |
| Ultra-fine wire, 0.025–0.08 mm | 24VX ultra-fine wire drawing machine | 24 dies, 1,500 m/min, ceramic capstans and low-noise flat-belt drive. |
| Tinned copper wire, 0.10–0.32 mm | Annealing & tinning machine | Even oven temperature, double tin furnace and double-deck take-up. |
| CCA wire, 0.08–1.2 mm | Copper-clad aluminium drawing machines | Ceramic or tungsten capstans and spray lubrication protect the copper layer. |
| CCS wire, 0.08–1.0 mm | Copper-clad steel drawing machines | Tungsten capstans, chain or flat-belt drive and controlled slip ratios. |
Tell us your wire. We will configure the line.
Share the incoming rod, finished diameter, material and target output. Our engineers will respond with a recommended machine configuration.